Q: What robot software and app software will be compatible with Razor Spray Tool?
A: For the Razor Spray Tool to work, you need to have your robot and tablet on following or above software:
App Software: 9.11.10 and above
Robot Software 9.15.0 and above
Q: What do I do if I can’t adjust the line width?
A: Clean the Razor Spray Tool using hot water and a brush.
Pour hot water on the slide rods to dissolve dried paint (use a brush if necessary) and try adjusting the line width again.
- DO NOT use high-pressure cleaning, as this can damage sensitive components.
Q: How do I adjust the line width?
A: Follow these steps or get a more thorough walk-through in the Razor Spray Tool - User Manual
- Power Down the robot.
- Use the Tool Plunger to move the entire tool to the very top hole (Raise Tool).
- Push the Push-Plunger (placed above the right disc) to release the disc mechanism and Lower Discs all the way.
- Open the Disc Lever (placed above the discs).
- Lift the Disc slightly, then slide it to align with the desired width mark (5 cm, 8 cm, 10 cm, or 12 cm).
- Rotate the disc downwards, ensuring the guides align and Close the Disc Lever to lock the position.
- Repeat for the other side.
- Stow Discs by rotating them upwards until they lock.
- Important: You must also adjust the nozzle height afterward.
Q: How do I adjust the nozzle height?
A: Follow these steps or get a more thorough walk-through in the Razor Spray Tool - User Manual
- Unlock the Twist Plunger (placed above the left disc) by turning it.
- Slide the Nozzle up or down based on the disc width and grass height.
- The goal is for the paint intersection point with the discs to be 10 mm to 30 mm (0.4 to 1.1 inches) above the grass height.
- Lock the Twist Plunger after adjusting.
Q: I’m getting tails on my lines, what can I do?
A: "Tails" are smears or thin marks left by the disc just before the line starts or after it ends, meaning the disc is coming down too early or going up too late.
- Tail at Line Start: The disc is coming down too early. Increase the "Trim Discs Start" slider value in the app (Settings > Robot Settings > Paint Settings) to make the discs come down later.
- Tail at Line End: The disc is going up too late. Decrease the "Trim Discs Stop" slider value in the app to make the discs go up earlier.
Q: I’m seeing clouds in the beginning or the end of my lines, what can I do?
A: "Clouds" are wider, soft, spray-like edges (fuzzy lines) at the start or end of the line, meaning the disc is coming down too late or going up too early.
- Cloud at Line Start: The disc is coming down too late. Decrease the "Trim Discs Start" slider value in the app (Settings > Robot Settings > Paint Settings) to make the discs come down earlier.
- Cloud at Line End: The disc is going up too early. Increase the "Trim Discs Stop" slider value in the app to make the discs go up later.